Skriv ut Lukk vindu


 

Høst 2018

SMN6200 Fluid Mechanics - 5 stp


The course is administrated by

Faculty of Engineering Science and Technology

Type of course

Emnet er forbeholdt studenter på studieprogram og kan ikke tas som enkeltemne.

Course contents

The students are going to investigate a given fluid flow problem using Computational Fluid Dynamics (CFD) and to make the necessary documentation and reporting from the project. This includes preliminary problem analysis, identification of flow characteristics, set up of numerical model, numerical simulations, post-processing, visualization and reporting from project.

As the visualizations should seek to give a better understanding of flow problem analysis and the results produced by the numerical fluid flow solver, the focus is on making sufficient & descriptive visualizations using available tools & techniques. 

A special focus will be on 3D-visualization techniques included/developed in the 5IT-master courses at the UiT-Narvik. However, other visualization methods may also be included.

Topic for student project and report-format will be presented by lecturer during in the start of the course.

Course content:

1. Introductory lectures to some basics of Fluid Mechanics, selected flow problem (case), identification of fluid characteristics, setup of numerical model, numerical simulations, post processing and visualization.

2. Short seminar on the basics of academic & technical reporting related to reporting structure and written format.

3. Individual project work to be carried out under supervision by lecturer.

4. Reporting structure and written format must be according to an academic report and a prescribed format will be provided.


Objective of the course

Knowledge

The student shall have the knowledge and understanding about;

 

Skills

The student should be able to;

 

General Competence


Language of instruction

English

Teaching methods

10 hours introductory lectures. Individual project run by the students under guidance by a supervisor.

Assessment

Course work requirement: Minimum requirements for reporting structure and written format prior to submission. Students have to use software at the UiT in Narvik.

Examination and assessment: Project report (100%). Letter grading A - F, where F is fail grade. There will not be arranged a re-sit exam for this course.


Date for examination

Take-home examination hand in date 20.12.2018

The date for the exam can be changed. The final date will be announced at your faculty early in May and early in November.


Recommended reading/syllabus

 The syllabus (project description) will be presented in the beginning of the course.
Lectures Autumn 2018